Table of Contents
Advertisement
T
roubleshooting
Vacuum cleaner won't turn on
possible causes
1.
Power cord not plugged in
2.
Blown fuse/tripped breaker
3.
Thermal protector activated
4.
Handle not fully attached
brush not rotating
possible causes
1.
Brush switch turned to "Off"
2.
Vacuum is in upright position
3.
Brush is jammed
4.
Brush needs to be reset
5.
Handle not fully attached
Vacuum cleaner won't pick up or low suction
possible causes
1.
Incorrect height setting
2.
Hose wand not properly positioned
3.
Dirt container not installed properly
4.
Dirt container full
5.
Clog in cleaner
6.
Filters are dirty
7.
Hose not properly attached
16
w w w . b i s s e l l . c o m
WaRnInG:
to reduce the risk of
electric shock, turn
power off and discon-
nect polarized plug from
electrical outlet before
performing maintenance
or troubleshooting.
Remedies
1. Check electrical plug
2. Check/replace fuse or reset breaker
3. Allow cleaner to cool for 30 minutes, see
pg. 13
4. Remove handle and reinstall
Remedies
1. Make sure brush switch is in "On" position
2. Recline vacuum to operate brush
3. Remove obstruction or debris (pg. 14),
unplug cleaner to reset brush (pg. 14)
4. Unplug cleaner to reset brush (pg. 14)
5. Remove handle and reinstall
Remedies
1. Turn dial to lower setting
2. Make sure hose wand is fully seated in
base and diverter is in down position
3. Check assembly of upper and lower portions,
correctly position and snap into place
4. Empty dirt container
5. Follow instructions on pg. 12-13 for
clearing clogs
6. Check and clean foam filter, check and
replace HEPA media filter cartridge if needed
7. Make sure hose collar is twisted to
lock position
8 0 0 . 2 3 7 . 7 6 9 1
Hide quick links:
Advertisement
Table of Contents
