Stopping; Emergency Stop - Volvo Penta D12-AUX Operator's Manual

Stopping

Let the genset run at no load for a couple of minutes before turning it off. This will keep the engine temperature in
balance and prevent it from boiling.
IMPORTANT! The procedure described above is
especially important if the genset has been run
at heavy loads.
IMPORTANT! If the genset stops abnormally, try
to locate the problem and make the repairs
needed before starting again. After starting the
genset, make sure it runs properly.

Emergency stop

If the engine can not be stopped by the engine control
system, the engine can be stopped as follows:
Push the emergency stop button.
If the engine cannot be stopped with the emergency
stop button, shut off the fuel supply or block the air in-
take to the turbocharger.
NOTE! If the engine has been stopped with the emer-
gency stop button, the button has to be reset (pull it
upwards) before the engine can be started again.
29