Canon GP-300 Online Manual page 203

Selecting Enable HTTPS redirection redirects the communication using CHMP to encrypted
communication.
Note
• To use CHMP for encrypted communication, you need to register the printer's root certificate to
your computer.
Registering Printer's Root Certificate to Local Computer for SSL Communication
• CHMP is a Canon proprietary protocol.
◦ Network interface settings ◦
To connect to a hub that supports STP, select Enable.
Selecting Enable perform the intermittent data reception when connecting to the network.
◦ ◦ DRX settings
Selecting Enable perform the intermittent data reception when connecting to the network.
◦ ◦ IP filtering
Allows or denies access for specific IP addresses.
Settings for both IPv4 and IPv6 addresses can be specified.
Important
• If the device address for administrator has been set to rejection by mistake, tap •
(Network) on the HOME screen of the operation panel, and then tap LAN settings > Wi-Fi /
Wireless Direct / Wired LAN > Settings > Advanced setup > Reset LAN settings, and
initialize network information of the printer.
After resetting, perform setup again as necessary.
◦ MAC address filtering settings ◦
Allows or denies access for specific MAC addresses.
Important
• • If the device address for administrator has been set to rejection by mistake, tap
(Network) on the HOME screen of the operation panel, and then tap LAN settings > Wi-Fi /
Wireless Direct / Wired LAN > Settings > Advanced setup > Reset LAN settings, and
initialize network information of the printer.
After resetting, perform setup again as necessary.
◦ ◦ Reset LAN settings
Initializes the network settings on the printer.
After resetting, perform setup again as necessary.
203