BWT ECOSOFT MO5000 Instruction Manual page 4

INSTRUCTION MANUAL ECOSOFT COMMERCIAL RO SYSTEM (MO5000, MO10000)
4
Reverse osmosis systems are designed at the latest technical level and are safe to operate.
Improper or not on purpose use can cause danger hazards to service staff. Therefore:
— It is necessary to read and strictly follow the instructions of this operating manual,
especially the safety rules!
— Keep the operating manual in an accessible place near the reverse osmosis
system.
— Commissioning and maintenance should only be performed by an authorized service
center!
— In any case, local safety and accident prevention regulations apply to the operation of
— the unit. They mustalways be considered and followed.
— Follow the instructions and warning signs.
— In case of injuries, accidents or skin irritations consult a doctor immediately.
— After long downtimes (> 72 hours), or at least once a year, it is necessary to disinfect
the system
Operational safety
Unsuitable raw water quality may result in inadequate or unacceptable permeate quality.
If the permeate flow rate is reduced more than 20%, it is also recommended to decrease the
number of connected consumers so as not to disrupt the functionality of individual connected
devices.
The unit may only be operated with the electrical cabinet closed.
Dry running of the pump is forbidden!
Do not modify, remove, bypass or bridge security devices.
Safety during supervision
When electrical cabinets are open:
Before starting maintenance and repair, the reverse osmosis system must be switched off by the
main switch and disconnected from the electrical grid.
This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2021
Reverse osmosis piping is under pressure!
Before doing any maintenance on the reverse osmosis systems, it is necessary
to relieve the pressure in the pipelines. Opening threaded connections or
valves can cause injury!
Electrical shock hazard!
Dangerous electrical voltage with open cabinet.
Switch off the reverse osmosis system with the main switch and disconnect it
from the mains.