Trane LCD Control Series Owners & Installation Manual page 13

- Touch FAN SPEED button to select the desired fan
speed level and the display will show Low (L), Medium
(M), High (H), and Auto (
DRY Mode
(Available when using with remote control)
- Press MODE button in remote control to select the
operation mode.
- will be shown on the status display when DRY
mode is selected.
- Touch either or
temperature between 15
- Touch FAN SPEED button to select the desired fan
speed level and the display will show Low (L),
Medium (M), High (H), and Auto (
Note:
• In DRY mode, if the compressor/valve stops working, fan
motor will be stopped; fan motor will operate when
compressor/valve operates.
• ECONO mode can not be activated during DRY mode
operation.
HEAT Mode
- Touch MODE button to select the operation mode.
- will be shown on the status display when HEAT
mode is selected.
- Touch either or
temperature between 15
- Touch FAN SPEED button to select the desired
fan speed level and the display will show Low (L),
Medium (M), High (H), and Auto (
AUTO Mode
- Touch MODE button to select the operation mode.
- will be shown on the display when AUTO mode is
selected.
- Touch either or
temperature between 15
- Touch FAN SPEED button to select the desired
fan speed level and the display will show Low (L),
Medium (M), High (H), and Auto (
Note:
• In AUTO mode, the system will automatically switch
between COOL mode and HEAT mode to maintain
equally room temperature and set temperature.
ACYSTAT-IOM-EN
Display Unit and Receiver Board
Touch Wired Control
) respectively.
button to set the desired
O C to 30 O C.
) respectively.
buttonutton to set the desired
O O
C to 30 C.
) respectively.
buttonutton to set the desired
O O
C to 30 C.
) respectively.
Timer Operation
(Available when using with remote
control)
Once you select the timer operation, the settings are
saved in the control. Thereafter, the air conditioner will
start operating under the same conditions when you simply
push the POWER button on the control.
ON TIMER Setting
You can set ON TIMER to start the unit operation
automatically at any desired time up to 24 hours as
real time.
Note:
• This function is available when using with remote
control only.
• No symbol shows on the status display.
OFF TIMER Setting
You can set OFF TIMER to stop the unit operation
automatically at any desired time up to 24 hours as
real time.
Note:
• This function is available when using with remote
control only.
• No symbol shows on the status display.
POWERCOOL Mode
remote control)
POWERCOOL mode rapidly maximizes the cooling
capacity in COOL or DRY mode. With this simply mode,
the user can easily get the maximum cooling capacity
and comfort.
- Press POWERCOOL button in remote control to select
POWERCOOL mode.
- will be shown on the status dissplay when
POWERCOOL mode is selected.
- The air-conditioner will accelerate capacity up totally
20 minutes or until room temperature is lower than 18
- When POWERCOOL mode completely operates or is
cancelled, will disappear from the display and
return to the former settings before POWERCOOL mode.
- To cancel POWERCOOL mode, press POWERCOOL
button in remote control again.
(Available when using with
O
C.
13