Flexcom TK306 Installation And Operating Instructions Manual page 24

Flexcom Communication Ltd
Send an alarm to the phone if the
vehicle moves, overturns or is hit. The
sensitivity of the sensor can be
adjusted in 3 levels.
The following two alarms are automatically activated when the standby mode is switched on and
deactivated when they are switched off.
Door open alarm: The device sends a "Door alarm + <position>" message to the
administrator phone every 3 minutes when the vehicle door is opened and the siren sounds
every 20 seconds for 20 seconds while the door is open.
Start alarm: The device sends an "ACC alarm + <position>" message to the administrator
phone every 3 minutes and the siren sounds every 20 seconds for 20 seconds while the ignition
is on.
If the device detects a door open, ignition, or SOS alarm event, it automatically takes a photo, which
is stored on the SD card.
To set the sensitivity, send
the following in advance
SMS message to the device:
**sensitivity123456 X**
where
- X = 1 (alarm even in case
of weak effect)
- X = 2 (alarm only in case
of moderate effect)
- X = 3 (alarm only in case
of strong effect)
and after this
Turning on: shock123456
Content of the alarm message:
„Sensor alarm <vehicle
position>"
Turning off: noshock123456
24/28
Installation and operating instructions (2021/03/08)