Gait up GO Instructions For Use Manual page 48

Fig 61. Possible sensor locations: back of the belt, foot, side of the belt
The Physilog6 sensor device accessory is worn either at the belt or on a foot depending on the test.
Therefore two fixation clips are provided with the sensor device: a belt and a shoelace clip.
To fix the Physilog6 sensor device in the belt clip, place the Physilog6 on the belt clip. The sensor
device can be clipped into the fixation clip in both directions. You need to clip the fixation connector
on the upper part of the fixation clip first, then push the lower half of the Physilog6 sensor device until
you hear a clicking sound. Once the sensor is attached to the fixation clip, it is possible to place the clip
at the belt of the test subject. The clip must not touch the participant's skin, use the belt strap over the
clothes if the subject is not wearing a belt. Carefully read the instructions given in the Gait Up GO
Mobile Application for the selected test to know where to place the sensor.
Fig 62. Sensor fixation using the belt clip
To fix the Physilog6 sensor device on the foot, use the shoe lace clip. Insert the clip without the sensor
device under the shoe laces. Take two rows of laces when possible to have better attachment. Then
place the Physilog6 sensor device on the clip. You need to clip the fixation connector on the upper part
of the fixation clip first, then push the lower half of the Physilog6 sensor device until you hear a clicking
sound. The sensor can be placed on the shoe without restrictions of orientation and position.
ENGLISH 48/84