Gait up GO Instructions For Use Manual page 18

Component Function
a) Body of the It includes a moulded non-flammable ABS casing which embeds the electronics
device and the battery of the Physilog6 sensor device. The electronics are composed of
a microcontroller with a wireless communication unit that transmits
bidirectional information between the device and the mobile phone/tablet, the
sensors (IMU, magnetometer and barometer), a power management circuitry, a
flash memory, a LED, a button, a beeper, a RF ISM ceramic antenna and a safety
circuitry. The sensor device is powered by an internal LIB battery (lithium-ion
battery), which is IEC 62133:2012 certified.
The Physilog6 sensor device is water and dustproof according to the standard
IP64.
b) LED It emits light indicating the different status of the sensor device;
c) Button The button serves to perform a reset of the device in case it is not responding
normally. See section 6. Troubleshooting for more information.
d) USB-C plug It allows the users and end-users to plug the USB cable included in the device
packaging on the one end to the Physilog6 sensor device and on the other end
either to a computer or to a compatible mobile phone charger (see
specifications on section 9 of the present document) for charging purposes.
e) Mechanical Mechanical design feature included in the Physilog6 casing and used to fit
connector for the mechanically the fixation clips into the body of the Physilog6 sensor device. The
fixation clips feature is symmetrically present on both extremities of the Physilog6 casing.
Table 3. Physilog6 sensor components
ENGLISH
● Charging
○ Blinking white
● Charged
○ Shining green
● Errors:
○ Blinking red:
■ Not enough battery to start a recording
■ Cannot start a recording
■ Error during a recording
■ Hardware part broken
● Recording
○ Blinking green
● Warnings:
○ Blinking yellow
■ Battery starting to be low during recording
18/84