Gait up GO Instructions For Use Manual page 45

Fig 54. Activated reports appear in the participant's tests - Android
All assigned tests appear in the participant's test list. After a test is performed and saved, the
corresponding test will be marked as completed for the day. However, the same test can still be
performed several times during the same day always following the recommendations given by the
medical professional. Each day at midnight, the list of performed tests will be reset and all tests will
again be shown as not done.
Preparing the device for Home use by the participant
The participant can use the device at home to perform assessments in between therapy sessions or to
have regular data points during long-term treatments. It is the medical professional's responsibility to
configure the Gait Up GO medical device according to the capabilities and safety requirements for
each Participant.
Before handing the device to the participant for home use, the medical professional should perform
the following steps:
● Install the Gait Up GO mobile application on the mobile phone/tablet which the participant
will take home and login with your medical professional account. Configure the Gait Up mobile
application for the participant. (see sections 4.3 to 4.5.6)
● Check the linked Physilog6 by clicking on the button in the top right corner. Check that the
indicated serial number is corresponding to the serial number of the Physilog6 which is
handed to the participant. To change the linked Physilog6, go back to the Dashboard and open
the "General settings" (see section 4.5.4).
● Check selected tests​ : Verify that the tests selected for the participant are adapted for home
use without your presence. Especially evaluate for each test if the participant can perform the
test safely. It is recommended to only assign tests which the participant has already performed
in your presence. (see section "Assign tests")
● Check if direct access to reports is active or not​ : for home use it is recommended to
inactivate direct access to reports. This allows the medical professional to keep control of the
credits and to avoid misinterpretation of the results by the Participant due to the absence of
the interpretation by the medical professional. (see section "Limited Admin mode")
● Start the Session for the Participant who will use the device at home. When the Participant
will open the Gait Up GO mobile application, the assessment session screen will be displayed.
● Inform the Participant (or the patient relative) about the frequency of performing the tests
(f.ex. once every day or week) and how to take care of the Physilog6 sensor accessory. Provide
the Participant (or patient relative, when applicable) the mobile phone/tablet, Physilog6 and
instructions for use and Quick start Guide for Lay person.
ENGLISH 45/84