Table of Contents
Advertisement
3.0 Installation Instructions
3.1 Moving Boiler to Installation Loca-
tion
▲ ▲
WARNING
!
SAFETY HAZARD
WHEN MOVING THE BOILER TO THE INSTAL-
LATION LOCATION, ENSURE THE STRUCTURE
(I.E. FLOORS, STAIRS, PEDESTALS) CAN SUP-
PORT THE WEIGHT OF THE BOILER, DOLLY
AND OTHER MOVING EQUIPMENT AND THE
PERSONNEL MOVING THE BOILER. FAILURE
TO FOLLOW THIS WARNING COULD RESULT
IN SERIOUS INJURY, DEATH, OR PROPERTY
DAMAGE.
▲ ▲
CAUTION
!
SAFETY CAUTION
Use caution when inserting and removing safety
blocks. Make sure boiler will not fall off safety
blocks.
Failure to obey caution could result in minor or
moderate injury.
1.
Move crated boiler as close as possible to the
location to be installed.
2.
If the boiler can not be moved with crate
assembled, uncrate the boiler fi rst (see sec-
tion 3.3) and use an appliance dolly capable of
handling the boiler weight to move the boiler
to the selected location.
3.
If required, the boiler jacket may be removed
to simplify handling. To remove the boiler
jacket, follow the steps below.
a. Remove the upper and lower front access
panels (See Figure 5).
b. Remove the top access panel. See Fig. 7.
c. The control panel is lowered by removing
two phillips screws that hold the attachment
Figure 3
clips to the left and right jacket panels. See
Figure 7. The metal control enclosure is
removed from the left and right jacket panels
by removing two phillips screws on each
side.
d. Remove the left and right boiler jacket
panels and the rear boiler boiler jacket panel
by removing the phillips screws and/or nuts
securing the panels.
e. Move and set the boiler.
f. Reassemble the boiler jacket. control panel
and access panel. Leave the top panel off
until the boiler is leveled.
Figure 4
Figure 5
18-CG03D1-4
11
Advertisement
Table of Contents
