Atlas Copco G 160 VSD Original Instruction Book page 30

stopped or Running Loaded is selected, the screen will jump directly to the regulation
menu after pressing the Enter key).
• Control mode icons
These icons are always shown in the main screen. If the icon is selected and the Enter
key is pushed, the screen jumps to the control mode menu. Following control modes
are available:
• Optional icons
These icons are only shown if their corresponding function is activated (e.g. week timer,
automatic restart after voltage failure, etc.)
• Pop up icons
These icons pop up if an abnormal condition occurs (warnings, shutdowns, service,...)
To show more information about displayed icons, select the icon using the scroll keys and
push the Enter key.
• Section C is called the Status bar
This bar shows the text that corresponds to the selected icon.
• Section D shows the Action buttons. These buttons are used:
• to call-up or program settings
• to reset a shutdown, service message or emergency stop
• to have access to all data collected by the controller
The function of the buttons depends on the displayed menu. The most common functions
are:
Designation
Menu
Modify
Reset
To enable an action button, highlight this button by using the Scroll keys and push the Enter
key.
To go back to the previous menu, push the Cancel / Escape key.
28
Local control
Remote control
Network control
Function
To go to the menu
To modify programmable settings
To reset a timer or message
Instruction book
APF221384