Side-To-Side Attachment - GLP Fusion Stick FS16Z User Manual

www.glp.de
3. Fasten the Clamp Brackets B to the mounting plates on the back of the fixture as
shown in Figure 8, inserting the quarter-turn fasteners and then turning the quarter-
turn fastener handles C a full 90° clockwise to lock them.
B
C
Figure 8. Clamp Brackets and rigging clamps
4. Hold the fixture up to the truss chord, pass the rigging clamps around the truss
chord, then tighten the clamps to install the fixture securely on the truss.
5. In temporary installations, secure each fixture with a safety cable as described in
'Securing fixtures with a safety cable' on page 18 if there is any risk that the fixture
will cause injury or damage if it falls.

Side-to-side attachment

See Figure 9. Locking channels A at both
ends of FS16Z fixtures accept FS16Z locking
pins B. This feature lets you align fixtures to
each other quickly and accurately to form
an unbroken line of pixels.
Warning! Do not use the locking channels and pins to support the weight of
fixtures unless the fixtures are hanging vertically one above the other. If
fixtures are not hanging vertically, each individual fixture must be supported
by fastening it securely to a surface or structure as directed in this chapter,
and the locking pins may be used for alignment purposes only
22
Installation
A
C
A
B
C
Figure 9. End channels and locking pins
Fusion Stick FS16Z
C
A
B
User Manual Rev. A