Before you begin, please make sure all parts and proper quantities are included. (See Part Identifier Key) Any parts damaged during shipment must be reported
within 24 hours of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303.
Step 1:
•
Place workfurface face down on protected flat surface so that the
threaded inserts are facing up.
Step 2:
•
Align mouting plates (attached to legs) with threaded inserts in
the worksurface.
•
Using a 4mm Allen wrench or 4mm hex bit, secure worksurface
with 1/4"-20x15mm joint connector bolts. DO NOT FULLY
TIGHTEN until
Step 6.
Step 3:
•
Remove the #12 star lock washers and
M6-1x10mm screws located in the legs.
(Location shown in
Fig.
•
Align holes in connector bar with pilot
holes in legs. Attach using #12 star lock
washers and M6-1x10mm screws. The bar
should rest inside the legs. DO NOT FULLY
TIGHTEN until
Step 6. (Fig A)
•
If you have an adjustable connector bar,
use #12 star lock washers and M6-1x14mm
screws to fasten the two connector bars
together. DO NOT FULLY TIGHTEN until
Step 6. (Fig B)
Step 4:
•
If assembling a desk with a foot rest bar, repeat
the location shown in the image to the right.
•
DO NOT FULLY TIGHTEN until
Tools Required
• Screw gun
• 4mm Allen wrench OR
• 4mm hex bit
• Phillips head screwdriver
wibenchmfg.com
Step 3
A.)
Step 6.
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
Assembly Instructions
UNE-T Desk/Table/Workstations
Fig. A
Star washers
and screws
located HERE
Step 3,
but in
Step 4
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Step 2
Fig. B
V101221 Version subject to change
Star washers
and screws
located HERE
1