Step 5:
•
If assembling a table/workstation with metal wire
management, align metal wire management with pilot
holes in the worksurface.
•
Attach wire management to worksurface using
#8x3/4" screws. Fasten down tightly.
Step 6:
•
Fully tighten leg, connector bar & foot rest (if foot rest
was ordered) with fasteners. Adjust leg height and
glides as needed.
•
With someone's help, turn table upright.
Step 7:
•
If assembling a table/workstation with grommet(s),
insert grommet(s) into the pre-determined location in
the worksurface.
To o l s R e q u i r e d
•
14mm open-ended wrench
Step 1:
•
Remove nylon glide from leg by rotating it
counterclockwise until glide is free.
Step 2:
•
Place stem of optional footing into the hole on the leg.
Rotate clockwise until fully inserted into leg.
Step 3:
•
Tighten with a 14mm open-ended wrench (for dual
wheel caster only).
Step 4:
•
Repeat for each caster/glide.
wibenchmfg.com
UNE-T Desk/Table/Workstations
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
Assembly Instructions
Step 5
with Dual Wheel Locking Casters
or 2.5" Grand Hank Glides
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Wire
management
2