Assembly - NordicTrack T14VT User Manual

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to
the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included hex key and your own Phillips screwdriver
let .
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses
is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it is preattached
to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assem-
bly. Extra hardware may be included.
Nut (20)–2
Upper Latch Bolt (4)–1
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side as shown. Partially
fold the Frame (55) so that the treadmill is more
stable. Do not fully fold the Frame until the
treadmill is completely assembled.
Insert an Extension Leg (97) into the base of the
Uprights (85) as shown. Tighten two Extension Leg
Bolts (87) into the bottom of the Extension Leg.
Attach two Base Pads (81) to the base of the
Uprights (85) with two 1" Tek Screws (82).
With the help of a second person, tip the tread-
mill over onto its right side. Attach the other
Extension Leg and Base Pads (not shown) as
described above.
With the help of a second person, carefully raise
the treadmill so that all four Base Pads (81) are
on the floor and the Frame (55) is in a vertical
position (see drawing 3).
All manuals and user guides at all-guides.com
1" Tek Screw (82)–4
3/8" Star
Washer (71)–4
Console Bolt (72)–4
Lower Latch Bolt (3)–1
Extension Leg Bolt (87)–4
1
55
97
7
, and rubber mal-
85
81
81
87
82