NordicTrack T14VT User Manual page 23

HOW TO OPERATE THE PERSONAL TELEVISION
IMPORTANT: Before operating the television, you
must connect a 75 ohm CATV cable to the 75 ohm
terminal on the treadmill. See page 10 for instruc-
tions.
Follow the steps below to operate the television.
1. Insert the key into the console.
See HOW TO TURN ON THE POWER on page
14.
2. Press the On/Off button to turn on the televi-
sion.
When the key is inserted, the television will auto-
matically turn on. If you have turned off the televi-
sion, turn it on by pressing the On/Off button.
3. Press the Channel buttons to select the desired
channel.
Note: Complete this step only if you are using ana-
log cable. Otherwise, change channels through an
external source such as your cable box or your
VCR.
All manuals and user guides at all-guides.com
23
When the television is turned on, the screen will
show the last cable channel that was selected. To
select a different channel, press the Channel but-
tons. The selected cable channel number will ap-
pear on the screen for a few seconds. Note: The
television is equipped with a channel memorizing
function that allows you to go directly from the cur-
rent channel to the next channel saved in memory.
Before channels can be selected in this way, they
must be saved in the televisionʼs memory. See
HOW TO USE THE INFORMATION MODE on
page 24.
4. Press the Volume buttons to adjust the volume.
When either Volume button is pressed, the volume
level indicator will appear on the screen for a few
seconds.
To use earphones or headphones (not included),
plug them into the headphone jack on the console.
5. When you are finished using the television,
press the On/Off button.
Press the On/Off button to turn off the television.
Note: Removing the key from the console will also
turn off the television.