KI All Terrain Binder Tower Assembly Instructions

Assembly Instructions
All Terrain Binder Tower
®
February 2014
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.

Caster with Outriggers Assembly

1. Locate the caster/hardware packet
that is shipped inside the binder
tower. Secure or remove any loose
components inside the tower.
2. Carefully turn storage tower on
it's back or upside-down on a soft
protective surface.
3. Thread the casters into the
outriggers. Locking casters must
be positioned to the front of the
cabinet as illustrated. Tighten the
jamb-nut of each caster to the
bottom of the tower with a wrench
(Figure 1).
4. Gently raise the cabinet to it's
upright position on the casters
(Figure 1).

Inboard Caster Assembly

1. Locate the caster/hardware packet
that is shipped inside the binder
tower. Secure or remove any loose
components inside the tower.
2. Carefully turn storage tower
upside-down on a soft protective
surface.
3. Thread the casters into the bottom
of the binder tower. Locking casters
must be positioned to the front of
the cabinet as illustrated. Tighten
the jamb-nut of each caster to the
bottom of the tower with a wrench
(Figure 2).
4. Gently raise the cabinet to it's
upright position on the casters
(Figure 2).