KI Aristotle Casegoods Overhead Paper Sorter Assembly Instructions

Figure 1
underside of shelf
Figure 3
1330 Bellevue Street • P . O. Box 8100 • Green Bay, WI 54308-8100 • Tel 1-800-424-2432 • www.ki.com
A s s e m b l y I n s t r u c t i o n s
valance attachment
bracket
valance
Figure 2
center divider
© 2008 KI All Rights Reserved • Litho in USA • Code KI-62016/HT/PDF/0308
A r i s t o t l e™ C a s e g o o d s
O v e r h e a d Pa p e r S o r t e r
M a r c h 2 0 0 8
Figure 4
7HP30 - Hardware Pack
5
#8 x
Wood Screws
#8 x 1
Wood Screws*
1 1 / " Angle
2
Bracket
6" Angle
Bracket
*Use only if tackboard is installed.
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and injury.
1. Carefully unpack all parts from
shipping container and place paper
sorter onto a soft, protective
surface. Identify parts below from
the "Hardware Pack" diagram &
Figure 4.
2. Prior to installation of paper sorter,
certain components must be
removed from overhead cabinet, if
tackboard present. Remove optional task light
(optional)
from under cabinet shelf. Remove
valance from under overhead
cabinet (Figure 1) and retain to
reinstall after step 6.
3. If required, place the optional
tackboard into position (Figure 2)
at this time, prior to installing paper
sorter. Later, in step 4, six #8 x 1
wood screws will be used to secure
6" bracket to back panel through
the optional tackboard. Caution:
That is the only use for #8 x
1 1
4. Position the paper sorter assembly
up under the lower shelf of the
overhead cabinet as illustrated
paper sorter assembly
(Figure 3) and mark a line onto the
shelf underside at the center divider
location to indicate where the
center bracket will be installed.
Remove the paper sorter assembly
and position small, 1
onto the line to mark, then pre-drill
the mounting holes to underside of
cabinet shelf (take care not to drill
to deep). Attach the small 1
angle bracket to the underside of
/ "
8
the shelf using #8 x
28
screws (Figures 3 & 4).
1 / "
4
6
1
4
1 / "
4
/ " screws.
2
1 / " bracket
2
1 / "
2
5 / " wood
8