KI Aristotle Casegoods Aluminum Leg Table with Acrylic Panels Assembly Instructions

aluminum
leg assembly
tabletop
Figure 1
stiffener bar
Figure 2
7HP37 - Hardware Pack
Assembly Instructions
Aluminum Leg Table with Acrylic Panels
#8 x 1"
wood screw
tabletop
(60" or longer)
#8 x 1"
16
screws
Aristotle Casegoods
®
December 2018
#8 x 1"
wood screw
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
1. Carefully place tabletop upside down
onto a soft, protective surface. One
at a time, position a leg assembly
over pre-drilled holes where it will be
installed. Some holes are pre-drilled
in the tabletop to aid in locating the
leg's mounting position (Figure 1).
2. Secure the aluminum leg assembly
to the underside of the tabletop
using eight #8 x 1" wood screws as
illustrated. Take care when tightening
to not strip screws in tabletop
underside (Figure 1).
3. If tabletop is 60" in length or longer,
a stiffener bar must be installed.
Align the four outside mounting
holes of the stiffener bar to the four,
pre-drilled mounting holes at the
underside of the top and secure
with #8 x 1" woodscrews. Use the
remaining mounting holes in the
stiffener bar as a template, and
secure the bar to the underside of the
tabletop, using a total of sixteen
#8 x 1" screws (Figure 2).