Table of Contents
Advertisement
Liquiflo Installation, Operation & Maintenance Manual
Section 1: General Information
1.1
General Instructions
This manual covers the Poly-Guard
The materials of construction of the pump are selected based upon the chemical compatibility of the fluid being pumped.
The user must verify that the materials are suitable for the surrounding atmosphere.
If the fluid is non-conductive, methods are available to mechanically ground the isolated shaft. This is only necessary if
the surrounding atmosphere is extremely explosive or stray static charges are present.
Upon receipt of your Liquiflo pump:
A)
Verify that the equipment has not been damaged in transit.
B)
Verify that the pump Model Number
and Serial Number are stamped on
the circular Stainless Steel Nameplate
on the pump's housing.
C)
For ATEX certification, verify that the following Stainless Steel Tag is secured to the pump:
Explanation of ATEX Tag
Group II
Explosive atmospheres
Equipment provides a high level of
Category 2
protection. Explosive atmospheres are
likely to occur.
Equipment provides a normal level of
Category 3
protection. Explosive atmospheres are
unlikely to occur.
D
Dust
G
Gas
D)
Record the following information for future reference:
Model Number:
Serial Number:
Date Received:
Pump Location:
Pump Service:
NOTE: By adding a K prior to the pump's Model Number, a Repair Kit can be obtained which consists of the following parts: drive and
idler gears, drive and idler shafts, wear plates, bearings, bearing lock pins, housing alignment pins, keys, retaining rings and O-rings.
(See page 17 and Appendix 2 for more information.)
Series Mag-Drive, Close-Coupled Gear Pumps – Models P1 thru P9.
®
3
®
Poly-Guard
Series MAG-DRIVE Gear Pumps
Models P1 thru P9, Close-Coupled
Advertisement
Table of Contents
