Advertisement
This Manual covers the "3" and "H" series Sealed pumps.
Upon receipt of your Liquiflo pump verify:
A)
The equipment has not been damaged in transit.
B)
The pump model number and serial number are stamped on the pump's rear housing.
RECORD
Model:_______________________ Serial No.____________________
NOTE:
which consists of the following parts: drive and idler gears, drive and idler shafts, retaining
rings, wear plates, keys, housing and bearing lock pins, o-rings and bearings.
A)
Work Safety Symbol
!
B)
Attention Symbol
ATTENTION
INSTALLATION OF PUMP AND MOTOR ASSEMBLY
ATTENTION
The following should be observed for proper installation of the pump.
A)
Pump should be accessible for servicing and inspection.
B)
The foundation area should be rigid and level for maintaining pump alignment.
C)
The inlet should be as close to the liquid source as practical and preferably below it.
D)
Piping should be supported. Do not use the pump as a pipe hanger.
E)
Install valves and unions to isolate the pump during maintenance.
GENERAL INSTRUCTIONS
By adding a K prior to the pump's model number a repair kit can be obtained
SYMBOL EXPLANATION
This symbol indicates remarks applicable to operational safety,
where risks for health and life of personnel may be posed. All
cautions should be passed on to other users.
Special attention must be paid in order to maintain a correct
operating procedure and to avoid damage to the pump and/or other
plant equipment.
All items included in this section.
P. 2
Advertisement
