Download Print this page
Defender EL00147 Quick Start Manual

Defender EL00147 Quick Start Manual

Shock/contact alarm

Advertisement

Quick Links

To use the unit with the magnetic contact with/without
the vibration function
The gap between the magnetic contact and the alarm
should be within 10mm so that the contact and the alarm
are close together when a door or window is closed. The
magnetic contact can be installed on either the left or right
hand side.
Follow the instructions under Vibration Function to
deactivate or activate as required.
Operation of the alarm
When exiting from the protected area
Press the number '4' on the keypad and the alarm will
sound a tone to indicate that the alarm is armed. You have
30 seconds to vacate the area, the red LED will flash once
when the alarm is active. After this time, if the magnetic
contact is broken, you have 5 seconds to enter your PIN. If
no PIN is entered the alarm will sound for 30 seconds, then
pause for 5 seconds. This will be repeated until your PIN is
entered or the magnetic contact is closed.
If vibration is detected
When vibration is detected the alarm will sound for 30 sec-
onds, then reset for 5 seconds. If vibration is detected again
the alarm will sound for 30 seconds. This will be repeated
until vibration stops or your PIN is entered.
When entering the protected area
Simply enter your four digit PIN code (default factory code
is '1234') within 5 seconds of entering the area. The unit will
sound a tone to confirm the alarm is disabled.
Care and maintenance
To clean the case, use a soft, slightly damp cloth with water
and wipe dry. Never use chemicals to clean the case, as
they may damage the plastic and cause the alarm to fail.
WARNING
The high output siren fitted to this quality alarm may cause
ear damage if used at close range for a prolonged period
of time. Keep away from children and pet's ears.
This product is designed for use as a deterrent; it does not
guarantee protection or personal safety.
CAUTION
• When testing the alarm, make sure you hold it at least at
arm's length away from your ear.
• The power source has a finite/limited life.
• DO NOT MODIFY THE ALARM.
• The alarm should be kept out of reach and audible range
of children and pets.
NOTE: Performance may be adversely affected following
prolonged exposure to extreme temperatures.
Shock/Contact Alarm
Dual Function Alarm
Solon Security
Unit 40
Manor Industrial Estate
Flint
Flintshire
CH6 5UY
Product Code: EL00147

Advertisement

loading

Summary of Contents for Defender EL00147

  • Page 1 To clean the case, use a soft, slightly damp cloth with water Dual Function Alarm Product Code: EL00147 and wipe dry. Never use chemicals to clean the case, as they may damage the plastic and cause the alarm to fail.
  • Page 2 Vibration function Introduction NOTE: when batteries are installed and replaced the The Defender Shock/Contact Alarm is a dual function vibration function will be activated. 130dBs alarm. The alarm can be triggered when vibration is detected or when the door/window is open Deactivating the vibration function and the magnets are separated.