McIntosh MP1100 Owner's Manual page 22

How to Operate the MP1100, con't
Control to select "DIGITAL OUT LEVEL, High"
as indicated on the Front Panel Information Dis-
play. Refer to figure 86.
DIGITAL OUT LEVEL
High
Figure 86
4. To change the Digital Out Level to Low, rotate the
Front Panel LOAD Control or press the p and
q Push-buttons on the Remote Control. Refer to
figure 87.
DIGITAL OUT LEVEL
Low
Figure 87
After approximately 6 seconds the Information
Display returns to indicate the Source Selection and
Settings.
SAMPLE RATE
The MP1100 provides two Analog to Digital Audio
Sample Rates 192kHz or 96kHz. This provides the
flexibility for choosing either the best sound quality
or the greatest compatibility with Digital Playback
Devices. Perform the following steps to change from
the default Sample Rate of 96kHz (greatest playback
device compatibility) to 192kHz (best sound quality):
1. Momentarily press the Front Panel INPUT Control
(TRIM) or the TRIM Push-button on the Remote
Control.
2. Rotate the Front Panel INPUT Control (TRIM) or
press the t and u Push-buttons on the Remote
Control to select "SAMPLE RATE: 96kHz, (Press
TRIM to Set)" as indicated on the Front Panel
Information Display. Refer to figure 88.
22
SAMPLE RATE: 96kHz
(Press TRIM to Set)
Figure 88
3. Press the INPUT Control (TRIM) or the TRIM
Push-button on the Remote Control. Refer to fig-
ure 89.
SAMPLE RATE
96kHz
Figure 89
4. Change to the Higher Sampling Rate by rotating
the Front Panel LOAD Control or p and q Push-
buttons on the Remote Control. Refer to figure 90.
SAMPLE RATE
192kHz
Figure 90
After approximately 6 seconds the Information
Display returns to indicate the Source Selection and
Settings.
MONO/STEREO MODE
By default the Stereo Mode is active for all Input
Sources however, any Input Source may be assigned
to Mono Mode. To change Stereo Mode to Mono for a
given Input Source, perform the following steps:
1. Select the desired Input Source.
2. Momentarily press the Front Panel INPUT Control
(TRIM) or the TRIM Push-button on the Remote
Control.
3. Rotate the Front Panel INPUT Control (TRIM)
or press the t and u Push-buttons on the Re-
mote Control to select "MONO / STEREO,
______ " as indicated on the Front Panel Informa-
tion Display. Refer to figure 91.
MONO / STEREO
______
Figure 91
4. Select MONO by rotating the Front Panel LOAD
Control or p and q Push-buttons on the Remote
Control. Refer to figure 92.
MONO / STEREO
____
Figure 92
After approximately 6 seconds the Information
Display returns to indicate the Source Selection and
Settings.
METER ILLUMINATION
The MP1100 Front Panel Meter Illumination may be
switched On or Off by performing the following:
1. Momentarily press the Front Panel INPUT Control
(TRIM) or the TRIM Push-button on the Remote
Control.
2. Rotate the Front Panel INPUT Control (TRIM) or
press the t and u Push-buttons on the Remote
Control to select "METER LIGHTS, On" as
indicated on the Front Panel Information Display.
Refer to figure 93.
METER LIGHTS
On
Figure 93
3. Rotate the Front Panel LOAD Control or p and
q Push-buttons on the Remote Control to select
"METER LIGHTS, Off" as indicated on the Front
Panel Information Display. Refer to figure 94.