Table of Contents
Advertisement
ed, except the Sample Rate,
Meter Illumination and
Display Brightness settings
of On or Off, which are the
same for all inputs.
Note: Selection and Adjust-
ment of all Trim
Functions may be
performed by press-
ing the Front Panel
INPUT Trim Control
and then rotating it
to select the desired
Trim Function. Then
use the LOAD Control
to change the setting.
The Remote Control
TRIM Push-Button
together with the
Directional Push-buttons can also be used. After
pushing the TRIM Push-button, use the
Push-buttons to select the desired TRIM Function,
and then use
and
Push-buttons to adjust the
p
q
selected TRIM Setting, refer to figures 60 and 66.
CARTRIDGE PROFILE
There are four default Cartridge Profile Settings and
the MP1100 has the ability to store up to five addition-
al Custom Cartidge Profile Settings. Refer to Setup
"Profile Store' on page 15 for additional information.
1. Select the desired PHONO Input Source.
2. Momentarily press the Front Panel INPUT Control
(TRIM) or the TRIM Push-button on the Remote
Control.
3. Rotate the Front Panel INPUT Control (TRIM) or
press the t and u Push-buttons on the Remote
Control to select "CARTRIDGE PROFILE, (Press
TRIM to Set)" as indicated on the Front Panel
Information Display. Refer to figure 67.
CARTRIDGE PROFILE
(Press TRIM to Set)
4. To select Profile momentarily press the Front Panel
INPUT Control (TRIM) or the TRIM Push-button
on the Remote Control. Refer to figure 68.
CARTRIDGE PROFILE
5. To select the desired profile (User Profile "U1")
rotate the Front Panel LOAD Control or press the
p and q Push-buttons on the Remote Control.
Refer to figure 69.
Figure 66
CARTRIDGE PROFILE
User Profile 1 (U1)
and
t
u
After approximately 6 seconds the Information
Display returns to indicate the Source Selection and
Settings.
RESISTANCE
Change the Resistance Load Setting for a selected
Phono Cartridge by performing the following Steps:
1. Select the desired PHONO Input Source.
2. Momentarily press the Front Panel INPUT Control
(TRIM) or the TRIM Push-button on the Remote
Control.
3. Rotate the Front Panel INPUT Control (TRIM) or
press the t and u Push-buttons on the Remote
Control to select "RESISTANCE, Ohm 47k"as
indicated on the Front Panel Information Display.
Refer to figure 70.
Figure 67
MM
Figure 68
Figure 69
How to Operate the MP1100
RESISTANCE
Ohm 47k
Figure 70
4. To select the resistance of 100 ohms, rotate the
Front Panel LOAD Control or press the p and
q Push-buttons on the Remote Control. Refer to
figure 71.
RESISTANCE
Ohm 100
Figure 71
After approximately 6 seconds the Information
Display returns to indicate the Source Selection and
Settings.
CAPACITANCE
Change the Capacitance Load Setting for a selected
Phono Cartridge by performing the following Steps:
1. Select the desired PHONO Input Source.
2. Momentarily press the Front Panel INPUT Control
(TRIM) or the TRIM Push-button on the Remote
Control.
3. Rotate the Front Panel INPUT Control (TRIM) or
press the t and u Push-buttons on the Remote
Control to select "CAPACITANCE, pF 50" as
indicated on the Front Panel Information Display.
Refer to figure 72.
CAPACITANCE
pF 50
Figure 72
4. To select the a capacitance of 300 pF, rotate the
Front Panel LOAD Control or press the p and
q Push-buttons on the Remote Control. Refer to
figure 73 on the next page.
19
Advertisement
Table of Contents
