McIntosh MP1100 Owner's Manual page 21

EQUALIZER
LP
Figure 77
EQUALIZER
NAB
Figure 78
EQUALIZER
AES
Figure 79
EQUALIZER
78
Figure 80
Note: For additional information on the Equalizer
Settings, refer to page 27.
After approximately 6 seconds the Information
Display returns to indicate the Source Selection and
Settings.
RUMBLE FILTER
Reduce unwanted Low Frequence Noise known as
Rumble by using the MP1100 Rumble Filter. To acti-
vate the Rumble Filter perform the following Steps:
1. Select the desired PHONO Input Source.
Note: Phono 1 was selected for this example.
2. Momentarily press the Front Panel INPUT Control
(TRIM) or the TRIM Push-button on the Remote
Control.
3. Rotate the Front Panel INPUT Control (TRIM) or
press the t and u Push-buttons on the Remote
Control to select "RUMBLE FILTER, Off" as
indicated on the Front Panel Information Display.
Refer to figure 81.
RUMBLE FILTER
Off
Figure 81
4. To activate the Rumble Filter, rotate the Front Panel
LOAD Control or press the p and q Push-buttons
on the Remote Control. Refer to figure 82.
RUMBLE FILTER
On
Figure 82
After approximately 6 seconds the Information
Display returns to indicate the Source Selection and
Settings.
SCRATCH FILTER
Reduce unwanted High Frequence Noises known
as Scratches by using the MP1100 Scratch Filter. To
activate the Scratch Filter perform the following Steps:
1. Select the desired PHONO Input Source.
Note: Phono 1 was selected for this example.
2. Momentarily press the Front Panel INPUT Control
(TRIM) or the TRIM Push-button on the Remote
Control.
3. Rotate the Front Panel INPUT Control (TRIM) or
press the t and u Push-buttons on the Remote
Control to select "SCRATCH FILTER, Off" as
indicated on the Front Panel Information Display.
Refer to figure 83.
SCRATCH FILTER
Off
Figure 83
How to Operate the MP1100, con't
4. To activate the Scratch Filter, rotate the Front Panel
LOAD Control or press the p and q Push-buttons
on the Remote Control. Refer to figure 84.
SCRATCH FILTER
On
Figure 84
After approximately 6 seconds the Information
Display returns to indicate the Source Selection and
Settings.
DIGITAL OUT LEVEL
The MP1100 provides the greatest possible Dynamic
Range when converting the Analog Audio Signal from
the playback of Phonograph Recordings to a Digital
Audio Signal. There are two Digital Output Settings
to accommodate a wide range of Dynamic Range. For
most recordings, the default setting of Digital Output
High Setting will produce excellent results. Refer-
ring to figure 85, if the word CLIP Flashes on the
MM PHONO 1
pF 50 CLIP Ohm=47K
Figure 85
Front Panel Information Display, switching the Digital
Output to the Low Setting will produce better results.
To change the Digital Out Setting from High to Low
perform the following steps:
1. Select the desired PHONO Input Source.
Note: Phono 1 was selected for this example.
2. Momentarily press the Front Panel INPUT Control
(TRIM) or the TRIM Push-button on the Remote
Control.
3. Rotate the Front Panel INPUT Control (TRIM) or
press the t and u Push-buttons on the Remote
RIAA
21