Table of Contents
Advertisement
Quick Links
IMPORTANT
Carefully remove all the parts from the carton and
place them individually on a soft cloth to prevent
scratches or other damage.
Carefully and strictly follow these assembly instructions
to ensure a completed product as designed.
Do not use power tools above 8 volts to assemble.
Part List
O.
Back
1 pc.
Hardware List
Hex Wrench
1 pc.
home
6800-58
Seating
E.
Foot
4 pcs.
Small
Hex Wrench
1 pc.
styles Customer Service: www.homestylesfurniture.com,
servicedesk@homestylesfurniture.com,
P.
Seat
1 pc.
J.
Clip
2 pcs.
M6x35
Head Cap Bolt
Spring Washer
20 pcs. (+1 extra)
20 pcs. (+1 extra)
888-680-7460
D.
Frame
2 pcs.
Flat Washer
20 pcs. (+1 extra)
Advertisement
Table of Contents
Related Manuals for Homestyles 6800-58
Summary of Contents for Homestyles 6800-58
- Page 1 6800-58 Seating IMPORTANT Carefully remove all the parts from the carton and place them individually on a soft cloth to prevent scratches or other damage. Carefully and strictly follow these assembly instructions to ensure a completed product as designed. Do not use power tools above 8 volts to assemble.
- Page 2 Assembly Instructions 2/5 IMPORTANT Ÿ Use a soft cloth between these parts and the floor. Ÿ Do not use power tools above 8 volts to assemble. Ÿ Do not tighten all the bolts until each part is properly assembled. Ÿ The unit must be level to work properly.
- Page 3 Assembly Instructions / 3 5 STEP 3 Attach Frame (D) to unit with Head Cap Bolts, Spring Washers and Flat Washers, tightening bolts only halfway. Tighten all bolts used in Steps 1, 2 and 3. Flat Washer Spring Washer Head Cap Bolt Head Cap Bolt Spring Washer Flat Washer...
- Page 4 Assembly Instructions / 4 5 For a sofa, follow instructions in 6800-57 carton, then complete Steps 5 and 6. For a 5, 6 or 7 seat sectional, follow instructions in 6800-401 and 6800-402 cartons. Sofa STEP 5 Attach left unit, middle unit and right unit with Clips (J). (See Figure 3) Left Unit Middle Unit...
- Page 5 Assembly Instructions / 5 5 Toggle Figure 4 Toggle STEP 6 Figure 5 Three 6800-CUS cartons are also needed for this step. Turn unit to its upright position. Attach Seat Cushions (F) to unit by pushing toggles through weaving in back of unit. (See Figure 4) Place Back Cushions (G) into position.
- Page 6 CARE INSTRUCTIONS NEVER NEVER use glass cleaners on allow liquids to remain on furniture. finished furniture. Ammonia Absorption causes parts to warp chemically attacks the finish. and split and finishes to delaminate. Do not use power tools Do not place Do not write above 8 volts to assemble.
Need help?
Do you have a question about the 6800-58 and is the answer not in the manual?
Questions and answers