Mechanical Installation; Dimensions Of Gate And Operator; Installing Base Plate; Emergency Release Mechanism - Chamberlain CHSL400EVC Installation Manual

Sliding gate operator

page of 112

/ 112
Contents
Table of Contents
Bookmarks

Table of Contents

Available languages

5. MECHANICAL INSTALLATION

Herewith you start mechanical installation of the gate operator.

5.1 Dimensions of Gate and Operator

CHSL400EVC

General information and conditions for set-up.

Before installing the gate operator ensure that the gate is running smoothly. The weight of the door is not allowed to be completely placed on the motor shaft.Ensure that

all the required cables (power cable, accessory cables etc) are prepared and laid correctly before the base plate is installed in the concrete.

NOTE:

All crushing points must be secured by an entrapment protection according the to EU: EN 12453, EN 60335-2-103; GB (UK, NI): BS EN 12453, BS EN 60335-2-103.

218

CHSL400EVC

4 m

5.2 Installing Base Plate

1. Take the anchor screw and put one nut untill the bottom of the tread. Add a washer and insert it from the bottom into base plate. Secure from top with a second nut.

2. Repeat for remaining 3 anchor screws (see picture 3).

3. Get the prepared cables (see picture 4) through the hole in the base plate.

4. Set the base plate into prepared concrete work. Ensure the plate is poisitoned correctly to the gate respecting the required space to gate and rack (see picture 1). The

arrow on the base plate needs to show towards gate. Align the base palte and finalise the concrete work.

5. Let the concrete base dry for at least 24h before proceeding (see picture 5).

NOTE: When installing a base plate ensure that later operator mounting and position adjustment with the setting screws is still possible at later stages if required.

Picture 3