Table of Contents
Advertisement
Projector Alignment
10
To adjust yaw (swivel): Loosen screw on projector mount assembly (B) indicated below until projector mount
can be rotated. Rotate mount to desired position and retighten screw.
To adjust pitch (forward and backward tilt): Turn knob on back of mount as shown below. Pull knob out and
turn by hand for easy adjustment or insert #2 phillips screwdriver in end of knob and turn.
To adjust roll (side to side tilt): Turn knob on side of mount as shown below. Pull knob out and turn by hand
for easy adjustment or insert #2 phillips screwdriver in end of knob and turn.
ARROW INDICATES
FRONT OF MOUNT
SCREW FOR YAW
(SWIVEL) STOP
KNOB FOR ROLL
ADJUSTMENT
To prevent tampering with the pitch and roll adjustments: Tighten the two tamper resistant security screws
10-1
on the projector mount assembly (B) using 4 mm security allen wrench (E) to lock the pitch and roll adjustments
as shown below.
NOTE: Tighten screws firmly, but do not overtighten. Overtightening can damage the mount.
• Do not adjust pitch or roll while tamper resistant security screws are fully engaged.
• Loosen the two tamper resistant security screws one complete turn before adjusting the projector mount assembly or
damage may occur.
FRONT VIEW
Visit the Peerless Web Site at www.peerlessmounts.com
B
CAUTION
TO LOCK ROLL TIGHTEN
TAMPER RESISTANT
SECURITY SCREW
12 of 12
For customer care call 1-800-865-2112 or 708-865-8870.
All other brand and product names are trademarks or registered trademarks of their respective owners.
KNOB FOR PITCH
ADJUSTMENT
fig. 10.1
SIDE VIEW
ISSUED: 03-17-08 SHEET #:055-9499-4 08-15-08
© 2008, Peerless Industries, Inc. All rights reserved.
BACK OF MOUNT
TO LOCK PITCH TIGHTEN
TAMPER RESISTANT
SECURITY SCREW
Advertisement
Table of Contents
