Maintenance; Tools And Supplies - formlabs Form Cure L Installation And Usage Instructions

6

Maintenance

To maintain the most efficient and long-lasting machine, ensure regular conservation. Formlabs
provides instructions to advise in installing, operating, and maintaining the machine. The Form
Cure L shall only be maintained by a qualified and trained person. Unauthorized disassembly
or repair procedures may damage the machine.
There are two groups of maintenance procedures: regular, which should be done after every
use, and intermittent maintenance, which only needs to be done occasionally. Please keep a
log detailing when each intermittent maintenance procedure was last performed.
For detailed guidance and visual assistance, visit support.formlabs.com.
Tampering with or disassembling the device prior to disconnecting the power
cable and waiting at least five minutes can subject users to potentially fatal
DANGER
electrical hazards. When removing the exterior paneling, disconnect the machine
from its power source before maintenance.
WARNING
• Formlabs provides instructions to advise skilled and unskilled persons in installing,
operating, and maintaining the Form Cure L. The Form Cure L shall only be
NOTICE
maintained by a qualified and trained person.
• Do not open the Form Cure L and/or investigate internal components unless under
the guidance of Formlabs Support or a certified service provider. Contact Formlabs
Support or a certified service provider for any additional guidance.
• Unauthorized disassembly or repair procedures may damage the machine and void the warranty.
6.1

Tools and supplies

Only use tools, chemicals, or procedures to maintain the Form Cure L that are outlined in this
manual, by prompts on the touchscreen, and on support.formlabs.com.
Do not use any tools, chemicals, or unapproved procedures with the Form Cure L unless
otherwise instructed to do so by Formlabs or a certified service provider.
• General purpose cleaner (e.g., glass cleaner) and/or soapy water
For cleaning the outer shells and display.
°
• Isopropyl alcohol (IPA), 90% or higher
For cleaning the work surface and tools.
°
• Low-fiber paper towels
For cleaning the work surface and tools.
°
For wiping residue grease, resin, or solvent.
°
• Non-abrasive microfiber cloth
For cleaning the outer shells and display.
°
26
Wear personal protective equipment (PPE) when performing maintenance
tasks. Use tools only as described.