Wiring Diagram
The wiring diagram below is depicted for point-to-point electrical connection checks used for troubleshooting or compo-
nent replacement. It is not intended to show the physical routing of wires. When replacing a wire or component, en-
sure the wire is routed in the same manner as the original factory wire. (Note: Wire colors may vary.)
NOTES
All circuits are power limited except the backup battery which is non-power limited.
•
Non-power limited wiring must be separated from the power limited wiring by at least 1/4 inch.
•
If desired, use a Honeywell 955WH Tamper Switch with the 28-2 bracket.
•