Quadra-Fire MT VERNON-AE Troubleshooting Manual page 26

MT VERNON-AE TROUBLE SHOOTING MANUAL
5. Removing the Combustion (Exhaust) Blower
a. The combustion blower is mounted in the bottom
right rear of the appliance. Figure 5.
b. Use an 11/32 nut driver to loosen all six nuts, but
do not remove. Rotate the blower and remove
from the housing. Figure 6.
c. Set the blower on the top of the housing for the stove
and place on the firebox floor for the insert. You do
not need to disconnect the wires. Figure 7.
d. Vacuum out the exhaust area. Figure 8.
e. A view of the inside of the exhaust area. Figure 9.
BLOWER LOCATION ON STOVE
Remove
Side
Panel
BLOWER LOCATION ON INSERT
Figure 5
9-30-2010
Combustion Blower
Remove (6) Nuts
Combustion Blower
PAGE 26
Loosen all 6 screws, but do NOT Remove
Figure 6
Set blower on top of housing.
Do not disconnect the wires.
Figure 7 - Stove is shown in this example
Vacuum out the exhaust area.
Figure 8
Figure 9
7020-057D