Watlow SD Series User Manual page 51

Display Parameter name
Description
[SoaH] Soak Step
[hour] Hours
[hour] The number of hours, (plus Min and
Sec parameters) equal the total soak
step time at set point under the
[soaH] step type.
[Min] Minutes
The number of minutes, (plus Hour
[Min]
and Sec parameters) equal the total
soak step time at set point under
the [soaH] step type.
[`SEc] Seconds
[ SEc] The number of seconds, (plus Hour
and Min parameters) equal the total
soak step time at set point under
the [soaH] step type.
[Ent1] Event Output 1
Selects whether Event Output 1 is
[Ent1]
on or off during the program step.
[Ent2] Event Output 2
Selects whether Event Output 2 is
[Ent2]
on or off during the program step.
[Ent3] Event Output 3
Selects whether Event Output 3 is
[Ent3]
on or off during the program step.
[WF; P ] Wait-for Process Enable
Select to enable Wait-for Process
[WF.P]
value.
[WPr] Wait-for Process Value
[WPr] The program will not begin to decre-
ment the soak time during the pro-
grammed step until process value is
equal to the Wait-for Process Value
setting. Once the Wait-for Process is
satisfied, this function is no longer
active for this step.
Note: Some values will be rounded off to fit in the four-character display. Full values can be read with Modbus. All temperature
parameters are in °F through Modbus.
* Low register numbers contain the two higher bytes; high register numbers contain the two lower bytes of the four-byte integer.
Decimal precision is implied at three decimal places unless otherwise noted.
Watl o w S eri es SD
Set- Range
(Integer values for Mod-
tings
bus in parentheses.)
0 to 99
0 to 59
0 to 59
[`Off] (0)
[``On] (1)
[`Off] (0)
[``On] (1)
[`Off] (0)
[``On] (1)
[`~no] (0)
[`YES] (1)
-1999 to 9999
(-1999000 to
9999000)
49
• •
Default Modbus*
(less 40,001
offset)
Read/Write
0 See page 53.
0 See page 53.
0 See page 53.
[`Off] (0) See page 53.
[`Off] (0) See page 53.
[`Off] (0) See page 53.
[`~no] (0) See page 53.
75 See page 53.
Chapter 1 0 Pr ofi li ng
Appears if:
Profiling version only.
(SD_ R - _ _ _ _ - _
_ _ _ )
Profiling version only.
(SD_ R - _ _ _ _ - _
_ _ _ )
Profiling version only.
(SD_ R - _ _ _ _ - _
_ _ _ )
Profiling version only.
(SD_ R - _ _ _ _ - _
_ _ _ )
Output 1 is set to
[Ent1].
Profiling version only.
(SD_ R - _ _ _ _ - _
_ _ _ )
Output 2 is set to
[Ent2].
Profiling version only.
(SD_ R - _ _ _ _ - _
_ _ _ )
Output 3 is set to
[Ent3].
Profiling version only.
Profiling version only.
(SD_ R - _ _ _ _ - _
_ _ _ )