Removing The Concord Transformer With Twinfix; Vehicles Suitable For Twinfix - CONCORD TRANSFORMER XT-PRO Manual

Table of Contents

_ REMOVING THE CONCORD TRANSFORMER WITH TWINFIX

To remove the CONCORD TRANSFORMER, pull the

TWINFIX button (09) forwards and move the seat fully

forwards. Next, slide the locking buttons on the outer sides

of the TWINFIX adapters (10) forwards until the safety

indicators are red.

Now pull the seat forwards and away from the ISOFIX points.

Lay the seat with the back on a flat surface.

Pull the TWINFIX button (09) and then press

down on the seat section of the child seat until

the TWINFIX adapters (10) are fully retracted!

To avoid damaging the outside of the seat,

check that the surface you place it on is clean,

smooth and as soft as possible!

Please refer to the additional "CAR FITTING LIST" leaflet for an overview of cars and

vehicle seats compatible with the CONCORD TWINFIX system at the time your child

seat was manufactured.

For a continuously updated version, please visit www.concord.de.

Table of Contents

Table of Contents

Do you have a question about the TRANSFORMER XT-PRO and is the answer not in the manual?