Notes On Installation Location - Kikusui KHA1000 Operation Manual

2.2

Notes on Installation Location

Install this product indoors, observing the following conditions:
 Do not use this product in a flammable gas atmosphere.
 Avoid places where this product would be exposed to high temperature or
 Avoid places with high humidity.
 Be sure to use this product indoors.
 Do not install this product in a corrosive gas atmosphere.
 Do not install this product in a dusty place.
 Do not use this product in a place that is not well ventilated.
 Do not place anything on this product.
 Install this product on a flat and stable floor.
 Do not use this product in a place around a strong magnetic or electric
2-6
Explosion or fire may be caused. Do not use this product near inflammables such
as alcohol and thinner or in an atmosphere containing their gases.
direct sunlight.
Do not install this product near a heater or in a place where the temperature
undergoes rapid change.
Operating temperature range: 0 °C to +40 °C (+32 °F to +104 °F)
Temperature range guaranteed by specification: 23±5 °C (73±41 °F)
Storage temperature range:
Do not install this product in humid places near a water heater, humidifier, or
water supply.
Operating humidity range:
Humidity range guaranteed by specification:
Storage humidity range:
Condensation may occur even within the operating temperature range. In this
case, do not use this product until it is completely dried.
This product is designed to be used indoors so that safety is secured.
Do not install this product in a corrosive gas or sulfuric acid mist. This may
cause conductor corrosion and poor connector contact, leading to product
malfunction/failure and a fire.
Dust adhesion may lead to electric shock and fire.
Secure a space wide enough to allow air to flow around the product.
Placing a heavy object on this product may cause a failure.
The product may drop or fall down, causing damage or human injury.
field, or in a place with strong waveform distortion and noise from an input
power supply.
Doing so may result in incorrect product operation.
-20 °C to +70 °C (-4 °F to +158 °F)
20 %rh to 80 %rh (no condensation)
20 %rh to 80 %rh (no condensation)
90 %rh or lower (no condensation)
KHA1000