Table of Contents
Advertisement
OPERATING INSTRUCTIONS
1. Place the soldering iron in the holder.
2. Turn the unit on with the power switch on the back of the unit.
3. Set the desired temperature using the TEMP UP and DOWN
buttons on the unit or by pressing one of the Preset Memory
Channels. This temperature will show in the lower right corner of
the display.
4. Wait for the unit to stabilize at the desired temperature. The actual
temperature of the heating element/soldering tip is displayed on
the top of the display. See page 5 for a detailed diagram of the
display screen.
5. Remove the iron from the holder and flood the tip with a good
quality rosin core solder-preferably 63/37 or 60/40 grade solder.
6. Wipe the tip across the moist sponge or dip the iron into the brass
sponge to remove excess solder. The tip should then be shiny.
7. The soldering iron is now ready to solder. Proceed according to
your standard working practice.
CELSIUS / FAHRENHEIT CONVERSION
To switch between displaying the temperature in Celsius or
Fahrenheit, press both the ▲ and ▼ and hold for 3 seconds. The
display will toggle between °C / °F.
MUTE / UNMUTE FUNCTION
The unit beeps when buttons are pushed or when the temperature
kicker bar is activated. To toggle between Mute and Unmute Mode,
press and hold the CH1 and CH2 buttons for 3 seconds. When the
unit is Muted a Red speaker with a line through it will appear, when
the unit is Unmuted a White speaker will appear.
SET MEMORY PRESET CHANNELS
Turn the unit on, set the desired temperature by pressing the
Temperature ▲ or ▼ arrows on the unit. Wait for the unit to
stabilize at the desired temperature. Then to set a Channel
Preset, press and hold the channel button to be programmed for 5
seconds. The unit will beep 3 times and the channel has been set.
FEATURES
- 6 -
Advertisement
Table of Contents
