●
LXIP must be connected to a network equipment featuring a 1000 Mbits/s Ethernet interface, or a 100
Mbits/s Ethernet interface but this one will limit the number of streams.
4.2. Software requirements
LXIP requires installation of the drivers included in the LXIP Kit version 2.02 or higher. This kit includes:
●
a WDM DirectSound driver
●
an ASIO driver, which installation is optional
4.3. Supported operating systems
LXIP runs under Windows 7, Windows 8, Windows 2008 Server, 32bit and 64bit versions, and Windows Server
2012, Windows 10, and Linux (not described in this manual).
5. SOFTWARE INSTALLATION AND CONFIGURATION
The installation of the software requires administrator rights on your computer.
Please visit the Digigram web site at w ww.digigram.com for the most recent driver.
In case you run a specific application developed or installed by a Digigram Partner, this application might require the
use of a given driver version. In this case, make sure that the updated driver has been approved by your supplier.
5.1. Installation under Windows operating systems
●
Shut down your computer, insert the LXIP card in a free PCI EXPRESS
computer.
●
Start the computer.
●
Once the Windows session is opened, click on "Cancel" when the "Found New Hardware" Wizard appears.
●
Right click Doubleclick on the L XIP Kit vxx.msi i con to launch the driver installation.
A "Welcome" message is displayed, click N ext to
continue.
LXIP
u ser Manual v1.04
TM
slot, and screw it on the frame of the
6
Need help?
Do you have a question about the LX--IP and is the answer not in the manual?