Advertisement
Document Title:
Fire prevention measures
Profile:
BHL, BL70 [GB]
Fire prevention measures
General
There is always a risk of fire. Find out which type of fire extinguisher to use, where it is located and how to use it.
The fire extinguisher in the machine should be located according to the figure or in an external box that can be
locked.
Fire-fighting equipment installed in or on the machine must be maintained in working order. Such equipment
should be regarded as a complement to the operator's own efforts in case of a fire.
The equipment should not be considered as a replacement of the operator's own fire fighting efforts.
Fire extinguishers mounted on the machine or used when working on the machine must fulfil certain requirements.
See the Operator's Manual.
At the slightest sign of fire, if the situation allows it and keeping in mind your own safety, take the following action:
drive the machine away from the danger area.
lower attachment(s) to their bottom position so that the attachment rests on the ground.
stop the engine by turning the ignition key to the "0" position.
leave the cab.
turn off the battery disconnect switch.
start fighting the fire and call the fire department if necessary.
Figure 2
Smoking and open flames are absolutely forbidden when filling fuel or any time diesel fuel is in contact with
the open air.
Smoking or open flames are absolutely forbidden close to the machine when filling fuel or at any time the fuel
system is in contact with the open air.
Diesel fuel is flammable and must not be used for cleaning. Use an approved solvent instead.
Remember that certain solvents can cause skin rashes and are usually flammable. Avoid inhaling solvent vapour.
Engine starting aids are flammable. Store such items in cool and adequately ventilated areas.
Remember that such aids must not be used in combination with electric preheating of induction air.
Cleanliness
Cleanliness is a decisive factor for operational reliability of the machine's systems. Therefore, keep the servicing area
clean. Oil or water make floors and steps slippery and are also dangerous in combination with electrical systems or
tools. Oily clothes or clothes drenched in grease constitute a serious fire hazard.
Check daily that the machine and equipment, such as underbody skid plates, are free from dirt and oil. This reduces
the risk of fire and makes it easier to detect defective components or loose parts.
Function Group:
191
Information Type:
Service Information
Service Information
Date:
2014/3/20
Advertisement
