Table of Contents
Advertisement
Troubleshooting
Symptom
The PRINT lamp is flashing fast.
The PRINT CARTRIDGE lamp is
flashing fast.
Printing stops midway, and the
PRINT lamp is flashing fast.
You cannot select 9PIC SAME or
9PIC MULTI in the menu settings.
The printed image has a black frame.
Others
Symptom
The Remote Commander supplied
with your camcorder does not work.
The picture from a TV or VCR does
not appear even when your
camcorder is connected to outputs on
the TV or VCR.
The melody or beep sounds for 5
seconds.
While charging the battery pack, no
indicator appears or the indicator
flashes in the display window.
Cause and/or Corrective Actions
• The inside of the printer has become too hot.
c Leave your camcorder until it cools down, then resume
printing images.
• The ribbon has run out.
c Replace the print cartridge with a new one. (p. 146)
• You have left the print cartridge in high temperature so that
the ribbon is damaged.
c Replace the print cartridge with a new one (p. 146)
• An error has occured during printing.
c Set the POWER switch to OFF (CHARGE) once, and then set
it to VTR on MEMORY again.
c Charge the battery, and reinstall it.
• Print paper is not inserted, and the still image to print is not
played back.
c Insert print paper, and play back the still image to print.
(p. 128, 149)
• If you record the image on "Memory Stick" with other
equipment other than this unit, the printed image may have a
black frame. This is not a malfunction.
Cause and/or Corrective Actions
• COMMANDER is set to OFF in the menu settings.
c Set it to ON. (p. 91)
• Something is blocking the infrared rays.
c Remove the obstacle.
• The batteries are inserted in the battery holder with the + –
polarities incorrectly matching the + – marks.
c Insert the batteries with the correct polarity. (p. 206)
• The batteries are dead.
c Insert new ones. (p. 206)
• DISPLAY is set to V-OUT/LCD in the menu settings.
c Set it to LCD. (p. 91)
• Moisture condensation has occurred.
c Remove the cassette and leave your camcorder for at least 1
hour to acclimatize. (p. 187)
• Some troubles has occurred in your camcorder.
c Remove the cassette and insert it again, then operate your
camcorder.
• The AC power adaptor is disconnected.
c Connect it firmly. (p. 21)
• Something is wrong with the battery pack.
c Contact your Sony dealer or local authorized Sony service
facility.
173
Advertisement
Table of Contents
