Sony DCR-TRV140E Operating Instructions Manual page 92

Dubbing only desired scenes
– Digital program editing
Step 2: Setting the VCR to
operate with the A/V
connecting cable
To edit using the VCR, send the control signal by
infrared rays to the remote sensor on the VCR.
When you connect using the A/V connecting
cable supplied, follow steps (1) to (4) below, to
send the control signal correctly.
(1) Set the IR SETUP code
1 Set the POWER switch to VCR on your
camcorder.
2 Turn the power of the connected VCR on,
then set the input selector to LINE.
When you connect a video camera recorder,
set its power switch to VCR/VTR.
3 Press MENU to display the menu.
4 Turn the SEL/PUSH EXEC dial to select
then press the dial.
5 Turn the SEL/PUSH EXEC dial to select
VIDEO EDIT, then press the dial.
6 Turn the SEL/PUSH EXEC dial to select
EDIT SET, then press the dial.
7 Turn the SEL/PUSH EXEC dial to select
CONTROL, then press the dial.
8 Turn the SEL/PUSH EXEC dial to select IR,
then press the dial.
9 Turn the SEL/PUSH EXEC dial to select
IR SETUP, then press the dial.
q; Turn the SEL/PUSH EXEC dial to select the
IR SETUP code number of your VCR, then
press the dial.
Check the code in "About the IR SETUP code"
(p. 94).
92
(4)
(1)
1
2
,
3
4
5
6
7
8
9
q;
(1)