Sony Digital Handycam DCR-PC100E Operating Instructions Manual page 161

Troubleshooting
Symptom
You cannot write a print mark on the
still image.
The photo save function does not
work.
Others
Symptom
The title is not recorded.
The cassette label is not recorded.
While editing using the i.LINK cable
(DV connecting cable), recording
picture cannot be monitored.
DV synchro-editing does not
function.
Cause and/or Corrective Actions
• The write-protect tab on the "Memory Stick" is set to
LOCK.
c Set the tab to write. (p. 115)
• The image that you will write a print mark is not being
played back.
c Press MEMORY PLAY to play back the image. (p. 138)
• The write-protect tab on the "Memory Stick" is set to
LOCK.
c Set the tab to write. (p. 115)
• The battery pack is dead.
c Install a charged battery pack or use the AC power
adaptor instead of the battery pack. (p. 14, 18)
Cause and/or Corrective Actions
• The tape has no cassette memory.
c Use a tape with cassette memory. (p. 89, 154)
• The cassette memory is full.
c Erase another title. (p. 93)
• The tape is set to prevent accidental erasure.
c Slide the write-protect tab so that red portion is not
visible. (p. 19)
• Nothing is recorded in that position on the tape.
c Superimpose the title to the recorded position. (p. 89)
• The tape has no cassette memory.
c Use a tape with cassette memory. (p. 96, 154)
• The cassette memory is full.
c Erase some titles. (p. 93)
• The tape is set to prevent accidental erasure.
c Slide the write-protect tab so that red portion is not
visible. (p. 19)
• Disconnect the i.LINK cable (DV connecting cable), and
connect it again.
• The input selector on the VCR is not set correctly.
c Set the selector to DV input position. If you use another
DV camcorder, set the power switch to VTR.
• The camcorder is connected to DV equipment of other
than Sony.
c Operate normal editing.
• Setting programme on a blank portion of the tape is
attempted.
c Set the programme again on a recorded portion.
(continued on the following page)
161