Sunny Health & Fitness SF-RB4936 User Manual page 15

CLEANING
The recumbent bike can be cleaned with a soft, clean, damp cloth. Do not use abrasives or
solvents on plastic parts. Please wipe your perspiration off the recumbent bike after each use. Be
careful not to get excessive moisture on the computer display panel as this might cause electrical
hazard or electronics to fail. Please keep the recumbent bike, especially the computer, out of direct
sunlight to prevent screen damage. Please inspect all assembly bolts and pedals on the recumbent
bike for proper tightness every week.
STORAGE
Store the recumbent bike in a clean and dry environment, away from children.
ADJUSTMENTS GUIDE
MOVING THE RECUMBENT BIKE
Lift the Rear Stabilizer (No. 5) and tilt the
recumbent bike until the transportation wheels on
the Left & Right End Caps (No. 18L/R) touch the
ground. Now you can transport the recumbent bike
to the desired location with ease.
ADJUSTING THE BALANCE
In order to achieve a smooth and comfortable ride,
you must ensure that the recumbent bike is stabled
and secured. If you notice that the recumbent bike
is unbalanced during use, you should adjust the
End Caps (No. 23) located on the rear stabilizer
until the recumbent bike becomes levelled with the
floor surface.
ADJUSTING THE TENSION
Adjust the tension by rotating the Tension Control
Knob (No. 25) clockwise to increase the level of
resistance. Rotate the Tension Control Knob (No.
25) counter-clockwise to decrease the level of
resistance.
Tension levels are set at Level 1 being the lowest
and Level 8 being the highest.
ADJUSTING THE SEAT
To adjust the seat forward or backward, press
down Brake Handle (No. 73), then slide the seat to
the desired position, lift the Brake Handle (No. 73)
to tighten.
14