Before You Begin; Step 1, Prepare Drawer For Panel Installation; Step 2, Remove Original Drawer Front; Step 3, Prepare Custom Panel - Monogram ZKW700S Installation Instructions Manual

Electric warming drawer
Hide thumbs Also See for ZKW700S:
Table of Contents

Advertisement

Available languages

Available languages

Installation
Instructions

BEFORE YOU BEGIN

Read these instructions completely and carefully.
IMPORTANT
for local in spec tor's use.
IMPORTANT
codes and ordinances.
Note to Installer – Be sure to leave these
instructions with the consumer.
Note to Consumer – Keep these instructions for
future reference.
Skill level – Installation of this custom panel kit
requires a qualified installer or service technician.
covered under the warranty.
TOOL AND MATERIALS REQUIRED
Cut resistant gloves
for drilling through wood panels)
PARTS SUPPLIED
This kit contains a mounting panel to support a trimless
custom drawer front up to 3/4" thick. The tubular
handle can be reinstalled onto the custom panel with
longer screws (not provided). Or, the original handle
can be replaced with a custom handle of your choice.
(Handle is not supplied.) Choose a custom handle to
match or complement cabinetry hardware.
IMPORTANT: The warming drawer should be
installed according to the installation instructions
packed with the product. The original drawer front will
be removed and replaced with a custom panel.
must be finished for best appearance.
31-2000654 Rev. 3
– Save these instructions
– Observe all governing
WARMING DRAWER CUSTOM
PANEL ACCESSORY KIT
ZXW900
For installation of 30" wide warming
drawer custom panel and custom handle.
design, should be constructed in the same manner
as typical cabinet doors.
manufacturer. Be sure to provide the exact
dimensions so that the panel is constructed
accurately.
match surrounding cabinetry handles.
1
PREPARE DRAWER FOR PANEL
INSTALLATION
2
REMOVE ORIGINAL DRAWER
FRONT
inside and three from bottom. Set these screws
aside – they are no longer needed.
prevent the possibility of falling.
3
PREPARE CUSTOM PANEL
cabinetry dimensions and spacings.
the metal panel on the custom panel and check the
squareness and correct placement of the metal panel,
and mark the hole for the indicator light. Confirm that
the hole marking provides the indicator light to the
right side of the custom panel appearance side.

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Zkw700pZtw900sZtw900pZkw700psnssZkw700ssnss

Table of Contents