Provide Cabinet Support; Flushmount Installation Preparation - Monogram ZKW700S Installation Instructions Manual

PROVIDE CABINET SUPPORT

IMPORTANT: When installed below a single or double
oven, check to be sure that any oven supports above
the warming drawer cutout.
drawer cutouts are required. Additional clearance may
be required if 2 x 4 blocks are used to support runners
or solid floor of the oven above.

FLUSHMOUNT INSTALLATION PREPARATION

PREPARE THE INTERIOR
Cut and install side cleats:
Cut side wood cleats to height of cabinet opening and
the front face of the cabinet.
Cut and install bottom cleat:
Cut bottom wood cleat to a height of 1" minimum,
a depth of the cabinet minus E and a width of the
cabinet opening D.
Install onto the cabinet floor between the side cleats,
push it all the way back against cabinet wall and make
sure its front face aligns with the front faces of the
side cleats (E gap from the front cabinet face).
31-2000654 Rev. 3
Installation Preparation
2"x4" or
Equivalent Runners
22"
A
A
C
D
E
B
Equivalent Runners
solid bottom, 2 x 4 or 2 x 2 runners.
with the bottom edge of the cutout.
– There is no way to level the drawer once it has been
installed. Be sure supports are level.
the runners or solid floor and must be capable of
supporting 150 lbs.
A Side cleats depth
B Bottom cleat height 1" min.
C Bottom cleat depth Cabinet depth
minus E
D Bottom cleat width
max. (30" minus
2 side cleat
thicknesses of
E All three cleats
inset from cabinet
front
TOP
C
VIEW
A
Front Face of Cabinet
E
2"x4" or
25"
30"
30" 27"
1" min.
Cabinet depth
minus E
25 ½" min. – 26"
2 side cleat
3/4" each)
D
A
E