Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION OPTIONS
Installation Below
a Single Oven
Min.
Inside
Oven
Cutout
A
1" Min. Above Toekick or Adjust
to Oven Installation Height
Models
When installed under a wall oven:
Warming drawers are approved for installation below
only certain specified wall oven models. See the
label attached to the top of the warming drawer for
approved models.
nearly flush with adjacent cabinetry doors.
the opening.
31-2000654 Rev. 3
Installation Preparation
Block Against Rear
to Bottom of Block
2" Min.
Allow 5/8"
Overlap on
All Sides
B
Dimensions
A
B
Installation Below
a Double Oven
Min.
Inside
Oven
Cutout
A
1" Min. Above Toekick
NOTE: Additional clearance between cutouts may be
required. Check to be sure that oven supports above the
Warming Drawer location does not obstruct the required
The rough opening for the drawer must be:
frame.
wide models.
clearance of overlaps.
NOTE: If you are installing in frameless cabinets, it
may be necessary to install 1/2" wide cleats to accept
drawer mounting screws. See drawer for mounting
screw locations.
Block Against Rear
to Bottom of Block
Allow 5/8"
Overlap on
All Sides
2" Min.
B
5
Advertisement
Chapters
Table of Contents
