Before You Call For Service; Warming Drawer - Monogram ZW9000 Owner's Manual

Save time and
money!
Review the
troubleshooting
tips on this
page first and
you may not
need to call for
service.
16
PROBLEM

WARMING DRAWER

WILL NOT WORK
DRAWER DOES NOT
SLIDE SMOOTHLY
OR DRAGS
EXCESSIVE
CONDENSATION
NO HEAT IN THE
PROOF SETTING
FOOD DRIES OUT
POSSIBLE CAUSE
• A fuse in your home may be blown or the circuit breaker tripped.
Replace the fuse or reset the circuit breaker.
• Warming drawer not plugged in. Plug in.
• Warming drawer controls improperly set. See the Using the Warming
Drawer section.
• Ball bearings are out of alignment. Fully extend the drawer and
push it all the way in. See the Care and Cleaning section.
• Drawer over-loaded or load unbalanced. Reduce weight to less than
50 pounds. Redistribute drawer contents.
• Liquid in warming drawer. Remove liquid.
• Uncovered foods. Cover food with lid or aluminum foil.
• Temperature setting too high. Reduce temperature setting.
• Incorrect Moisture Selector setting. Set the Moisture Selector to
the open vent setting to allow venting.
• Room temperature may prevent the thermostat from tripping on.
Turn the knob to LOW then back to PROOF.
• Moisture escaping. Cover food with lid or aluminum foil.

Before You Call For Service...

Electric Warming Drawer
GE Appliances & Lighting
General Electric Company
Appliance Park
Louisville, KY 40225
GEAppliances.com