Page 1
INSTALLATION INSTRUCTIONS ZJ7000 and ZW9000 Electric Warming Drawer monogram.com...
Page 2
Insure that the power cord does not contact the hot surface on the bottom of ovens, cooktops, or other appliances. If you received a damaged warming drawer, you should contact your dealer For Monogram local service in your area, 1.800.444.1845. For Monogram Service in Canada, call 1.800.561.3344.
Choose a custom handle to match or designed to fit 30” warming drawers manufactured after complement cabinetry hardware. January 2015. For more Accessories or purchasing information please refer to Assistance/Accessories section of Monogram Warming Drawer Owner’s Manual. 31-10700-6...
Design Information GROUNDING THE APPLIANCE Please read carefully. Do not use an extension cord or adapter plug with this appliance. Follow National electrical codes or prevailing local codes and ordinances. This warming drawer must be supplied with 120V, 60Hz, and connected to an individual, properly grounded Recessed branch circuit, and protected by a 15 or 20 amp circuit Receptacle...
Installation Preparation INSTALLATION OPTIONS Installation Below Installation Below a Single Oven a Double Oven 23-1/2” 23-1/2” Min. Min. Inside Inside 2x2 or 2x4 Anti-Tip 2x2 or 2x4 Anti-Tip Block Against Rear Block Against Rear Wall, 9” From Floor Wall, 9” From Floor to Bottom of Block Oven to Bottom of Block...
Installation Preparation INSTALLATION BELOW A COUNTERTOP Electrical Outlet 42” Electrical Outlet Max. From Right Side Install 2x4 or 2x2 1-1/2” Cabinet Top Flush With Side of Anti-Tip Block Against Cabinet 7” Max. 25” Rear Cabinet Wall 9” 7” From Floor to Bottom Electrical Install a Solid Barrier of Block...
Installation PROVIDE CABINET SUPPORT 2”x4” or 2”x4” or Equivalent Runners Equivalent Runners 23-1/2” 23-1/2” 22” 25” 27” 30” IMPORTANT: When installed below a single or double The support must be level and rigidly mounted, flush oven, check to be sure with the bottom edge of the cutout.
WARMING DRAWER CUSTOM Installation PANEL ACCESSORY KIT ZXD30B Instructions For installation of 30” wide warming drawer custom panel and custom handle. BEFORE YOU BEGIN The custom drawer front panel, both raised and flat design, should be constructed in the same manner as Read these instructions completely and carefully.
Page 11
Installation STEP 4 SECURE CUSTOM PANEL STEP 7 REINSTALL ORIGINAL HANDLE OR OPTIONAL TO METAL MOUNTING CUSTOM HANDLE PANEL A custom handle (not supplied) may be installed. Lay the custom panel, appearance side down, on a clean surface. Drill pilot holes through the front of the custom panel and through the metal panel to match the chosen Remove all tape and packing material from the metal handle.
Installation PROFESSIONAL STYLE PANEL ACCESSORY KIT Instructions ZXD9030P BEFORE YOU BEGIN STEP 2 REMOVE ORIGINAL Read these instructions completely and carefully. DRAWER FRONT IMPORTANT – Remove the three screws from the bottom of the Save these instructions drawer edge. for local inspector’s use. Observe all governing codes and ordinances.
Page 16
NOTE: While performing installations described in this book, safety glasses or goggles should be worn. For Monogram ® local service in your area, call 1.800.444.1845. NOTE: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice.