Step 4, Secure Custom Panel To Metal Mounting Panel; Step 6, Install Lamp Jewel; Step 7, Reinstall Original Handle Or Optional Custom Handle; Step 8, Install Assembled Panel To The Drawer - Monogram ZKW700S Installation Instructions Manual

4 SECURE CUSTOM PANEL TO
METAL MOUNTING PANEL
clean surface.
metal panel.
side of the custom panel, with the mounting flanges
facing up.
panel.
metal panel to the custom panel.
5A
FOR PANELS LESS THAN
3/4" THICK
metal panel. Avoid adhesive within 1" of lamp hole
area and outer edges.
FOR 3/4" (OR GREATER)
5B
THICK PANELS
metal panel over the back side of the custom panel
and drill pilot holes. Drill pilot holes sized to match
screws being used (screws not provided).
NOTE: Select screw length carefully to avoid
penetration of the finished side.
6
INSTALL LAMP JEWEL
jewel to the front of the wood panel. On the side
with the bulge, (see illustration) apply a small bead
jewel into the drilled hole.
This Side
Appearance
Against
Side
Wood
10
Installation
7
REINSTALL ORIGINAL HANDLE
OR OPTIONAL CUSTOM HANDLE
panel and through the metal panel to match the
chosen handle.
NOTE: The handle screws should be installed through
the metal panel, the custom panel and into the
custom or original handle.
8
INSTALL ASSEMBLED PANEL TO
THE DRAWER
with the holes in the exposed drawer front and
marked the screw hole locations onto the custom
panel.
extend into the custom panel slightly.
custom panel assembly to the exposed drawer front
with seven screws.
NOTE:
Insert
at Monogram Appliances. Therefore, materials,
Jewel
appearance and specifications are subject to change
without notice.
Custom Handle
or Original Handle
31-2000654 Rev. 3