Provide Cabinet Support; Step 1, Anti-Tip Brackets; Step 2, Install Warming Drawer - Monogram ZJ7000 Installation Instructions Manual

Electric warming drawer
Table of Contents

Advertisement

Available languages

Available languages

PROVIDE CABINET SUPPORT

Equivalent Runners
23-1/2"
IMPORTANT: When installed below a single or double
oven, check to be sure
that any oven supports above the cutout do not obstruct
the 23-1/2" required depth of the warming drawer cutout.
■ A 2" min. clearance between oven and warming
drawer cutouts are required. Additional clearance may
be required if 2 x 4 blocks are used to support runners
or solid floor of the oven above.
■ The warmer drawer may be supported by either a
solid bottom, 2 x 4 or 2 x 2 runners.
INSTALL ANTI-TIP BRACKETS
WARNING
ANTI-TIP PRECAUTIONS
An anti-tip brace must be installed to prevent the
drawer from tipping forward when opened and
loaded. Failure to do so could result in personal
injury.
INSTALL WARMING DRAWER
■ Slide the left corner of the drawer into the opening.
■ Push the power cord into the hole leading to the
outlet location. Thread the cord through as the drawer
is being pushed back into the opening. Check to be
sure the power cord does not get trapped under the
drawer.
– If the outlet is installed inside the opening, plug the
cord into the outlet. In this location, the excess power
cord length should be coiled and taped to the right
side of the unit.
■ Push the drawer back until the front flange is flush to
the cabinet front.
31-10700-6
Installation
2"x4" or
22"
27"
Equivalent Runners
23-1/2"
■ The support must be level and rigidly mounted, flush
with the bottom edge of the cutout.
– There is no way to level the drawer once it has been
installed. Be sure supports are level.
■ The entire weight of the drawer is supported by
the runners or solid floor and must be capable of
supporting 150 lbs.
9"
2x4 or 2x2
Runners or
Solid Bottom
■ Open the drawer fully.
■ Drill pilot holes through the holes in the overlapping
frame, one on each corner.
• Drive the wood screws provided into each corner.
2"x4" or
25"
30"
Install 2x4 or 2x2
Anti-Tip Block
Against Rear
Cabinet Wall 9"
From Floor to
Bottom of Block
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zw9000Zw9000 w/ zxd9030pZw9000 w/zxd30b

Table of Contents