Installation Options - Monogram ZJ7000 Installation Instructions Manual

INSTALLATION OPTIONS

Installation Below
a Single Oven
23-1/2"
Min. Inside
Oven
Cutout
9"
9-1/4"
A
1" Min. Above Toekick or Adjust
to Oven Installation Height
When installed under a wall oven:
Warming drawers are approved for installation below only
certain specified wall oven models. See the label attached to
the top of the warming drawer for approved models.
• When installed, the front face of the drawer will be nearly
flush with adjacent cabinetry doors.
• Drawer overlaps will conceal cut edges on all sides of the
opening.
Installation Preparation
2x2 or 2x4 Anti-Tip
Block Against Rear
Wall, 9" From Floor
to Bottom of Block
2" Min.
Allow 5/8"
Overlap on
All Sides
23-1/4"
10-1/2"
B
Dimensions
ZW9000
ZJ7000
Installation Below
a Double Oven
23-1/2"
Min. Inside
Oven
Cutout
9"
9-1/4"
A
1" Min. Above Toekick
NOTE: Additional clearance between cutouts may
A B
be required. Check to be sure that oven supports
28-1/2" 30"
above the Warming Drawer location does not obstruct
25-1/2" 26-3/4"
the required interior 23-1/2" depth and 9-1/4" height.
The rough opening for the drawer must be:
– Depth: 23-1/2" min. from inside back to front of cabinet
frame.
– Width: 25-1/2" for 27" wide models, 28-1/2" for 30" wide
models.
– Height: 9-1/4".
– Allow 2" min. between oven and drawer cutouts for
clearance of overlaps.
NOTE: If you are installing in frameless cabinets, it may
be necessary to install 1/2" wide cleats to accept drawer
mounting screws. See drawer for mounting screw locations.
7
2x2 or 2x4 Anti-Tip
Block Against Rear
Wall, 9" From Floor
to Bottom of Block
Allow 5/8"
Overlap on
All Sides
2" Min.
23-1/4"
10-1/2"
B