Safety Cut-Out - Morphy Richards 73333 Instruction Booklet

VC73332MUK Rev5_Instruction Booklet 22/09/2011 10:43 Page 7
5 Using a flat bladed
screwdriver or a coin,
rotate the three cover
fixings, a quarter-of-a-turn,
from lock to unlock J.
Lift the base cover ˜ from
6
the rear fixing area first, the
cover will rotate forward.
Unhook the cover from the
front edge and remove.
Removing brush
bar & belt
Lift the metal belt guard ¯
7
out of the floor nozzle and
put it safely to one side K.
8 Slide the belt past the end
of the motor drive shaft ˘.
If the belt has broken,
remove all pieces and clean
the drive shaft.
9 Lift the rotating brush
equally at both ends to
slide it free of the floor
nozzle L.
L
Holding the ends of the
brush, check it rotates
freely or not, if not, it must
be replaced. Call our
Helpline for replacement
parts or belts.
Re-fitting brush
bar & belt
10 Hook the belt
drive shaft (the belt must
be slid sideways past the
end of the drive shaft).
NOTE: The belt guard must
have been removed first,
see point 7 above.
11 Refit the belt guard,
ensuring it is correctly
located. Press down fully.
For details of other Morphy Richards products, please see our website:
12 Pass the rotary brush
through the belt, ensuring
the correct end is located
against the belt M.
M
13 Pull the brush forward
(against the pull of the belt)
and locate the square ends
of the brush into location
slots in the floor nozzle M.
14 Rotate the brush by hand
to ensure the belt is running
in the centre of its location
on the brush.
Refitting the floor
nozzle base cover
15 Hook the base cover ˜
into the front of the floor
nozzle, ensuring all four
hooks are engaged N.
N
˜
16 Rotating the cover
downwards and rearwards,
slowly close the cover.
17 Tighten the three fixings,
over the using a screwdriver to turn
the fixings a quarter-of-a-
turn to the lock position J.
NOTE: If the cover will not
fully close or fixings will not
lock, lift the cover slightly
and rotate the fixings until
they are in the correct
position for closure.
18 Return the cleaner to the
upright position, re-fit the
dust canister and front
cover. Connect to the
mains supply. Switch on to
test.

SAFETY CUT-OUT

If the cleaner overheats, a
motor protection thermostat
will automatically switch the
motor off. If this happens,
switch the cleaner off,
unplug from the power
supply and leave the cleaner
to cool for at least 60
minutes. Check the airways
for blockages, empty the
dust canister and clean the
filters before restarting.
HELPLINE
If you have any difficulty
with your appliance, do not
hesitate to call us.
We are more likely to be
able to help than the
store from where you
bought it.
Please have the following
information ready to enable
our staff to deal with your
query quickly.
• Name of the product
• Model number as shown
on the underside of the
appliance.
• Serial number as shown on
underside of the appliance.
UK Helpline 0844 871 0960
Replacement Parts 0844 873 0726
Ireland Helpline 1800 409 119
WEBSITE
You may also contact us
through our website, or visit
the site to browse and
purchase appliances, spare
parts and accessories from
the extensive Morphy
Richards range.
7